How do you change a belt on a Maytag Atlantis washer?

When the belt in your washer begins to wear down, it may slip occasionally. The basket in your washer may also spin erratically or it may stop spinning altogether once the belt breaks. When the belt has broken, the washer will fill with water and function normally except the basket won’t spin.

How to Check and Replace Your Maytag Washer’s Drive Belt

  1. Unplug the washing machine and turn off both the hot and cold water supply lines.
  2. Tilt the machine so it’s lying on its front panel.
  3. Remove the shield from the bottom of the appliance.
  4. Remove the belt.
  5. Insert the new belt.
  6. Put the shield back into position.
  7. Lift the machine upright.

Beside above, what happens when the belt breaks on a washing machine? When the belt in your washer begins to wear down, it may slip occasionally. The basket in your washer may also spin erratically or it may stop spinning altogether once the belt breaks. When the belt has broken, the washer will fill with water and function normally except the basket won’t spin.

Similarly, where is the belt located on a Maytag washer?

The pump belt is located between the motor and pump underneath the washer. Simply remove the belt and hook the new one around the pulley. You may need to loosen or tighten the belt to ensure it is set in place properly. I removed the 2 phillips screws on the bottom of the front panel.

Why is my Maytag washer not spinning?

One common cause why a Maytag top load washer won’t spin is due to an uneven load or jammed clothing. Larger items or loads tend to settle on one side of the washer drum during a cycle. Try to redistribute the load or remove a few articles of clothing and run the spin cycle on your washer again.

How do I tighten the belt on my washing machine?

Press the motor into the washing machine and downward or toward the edge of the appliance. With the motor pressed firmly in place, tighten the mounting nut by turning the wrench clockwise. Keep a finger on the belt; when you can depress it only about 1/2 inch with your thumb, you have reached proper tension.

How do I know if my washing machine belt needs replacing?

Determine if the washer pumps water out after the wash cycle but does not spin, which indicates that at least one belt may be broken. Most washers have one or two belts. If the spin speed is too slow or items are very wet at the end of the cycle, the belt may be worn out or may have slipped.

Why the washing machine is not spinning?

If your washer fills with water but doesn’t agitate, the problem is likely to be a faulty lid switch, a broken belt, or a problem with the motor. 1 Check the washing machine’s spin cycle. If this works, the motor is operating and the belt is not broken. If the spin cycle doesn’t work, the belt may be loose or broken.

What causes a washing machine to not spin and drain?

If the washer won’t drain there might be a clogged pump or hose. It’s common for small socks or other small clothing items to get into the water drain system and clog the hose leading to the pump or the pump itself. If the washer won’t drain the lid switch assembly might be defective. This is a very common problem.

Is it worth replacing washing machine bearings?

It’s possible to replace these, but it will depend on the make and model. Some cheaper models and newer machines have sealed outer drums, so you can’t replace the bearings – you have to replace the whole drum. With a new drum costing more than £100, plus labour costs, it may be more cost-effective to buy a new machine.

Can belts go in the washing machine?

Belts. Woven belts (not leather) are fine to add to a normal load of laundry. Make sure to put it in a mesh wash bag so the metal hardware doesn’t damage your machine.